antvur.blogg.se - Autodesk inventor hsm ultimate

Fixed a crash when running simulation of a weldment assembly.

Block post-processing if an operation is calculating.

Fixed issue when selecting a tool from different operation in the tool library did not use the desired feedrates and speeds.

Show number of holes being machined for Drill.

Improved stock simulation of simultaneous multi-axis toolpath.

Added support for back cutting (used for Sandvik PrimeTurning) for Turning Profile.

The main cutting direction (normally Climb) will be the preferred cutting direction but the opposite direction will be used when the alternative non-engaging stay down linking would be estimated to be longer.

You can use this feature to reduce machining time further when roughing depending on the material you are machining. When both ways is enabled you can set a separate load and feedrate for the opposite cutting direction.

Added support for both ways Adaptive Clearing.

You can use this feature to break the chips.

Added support for pecking for Turning Profile.

Added 2D Profile strategy (similar to Fusion 360).

The following changes were made in an earlier update (2018.3):

Post Processing: Fixed issue where getGlobalParameter() always returns the value in MM #9347.

Fixed regression where Mouse clicking no longer worked after renaming a browser node #9282.Fixed crash due to invalid plane/origin for protected operation #9317.Fixed unsupported stroke scaling for Internet Explorer / Edge browsers #9352.Fixed crash in “Flow” when switching Flow direction #9368.Fixed issue that disabled the direction arrow after clearing geometry input in Flow and Swarf #9397.The following changes have been made in the current update (2018.3.1): Inventor HSM Ultimate (formerly Inventor HSM Pro).Inventor HSM Premium (formerly Inventor HSM).This document covers all three Inventor HSM products: